The company's solenoid valve, the life of high-frequency electromagnetic valve in the DC voltage conditions, up to 100 million times or more; three points high pressure and high flow solenoid valve pilot design, piping for the three-in-pipe, flow aperture of 10 Millimeters, use pressure from 0.5e to 20kg are applicable.
Reverse osmosis (RO) special plastic solenoid valve is 1/8 caliber, with a small volume and low cost advantages, specifically for the use of drinking fountains.
The 1/2 solenoid valve greatly changes the structural design in the coil part, and it can supply ISO specifications, waterproof capacity up to IP65, heat resistance with F class 155 degrees and H class 180 degrees two, and even can supply ISO joints separately.
Chainsaw: Gasoline chainsaw. This is the smallest kind of chainsaw. It is powered by a small two-stroke gasoline engine, similar to the Brush Cutter, Outboard Motor, driven by a sprocket, and runs on the guide board through a dedicated cutting saw chain to achieve the purpose of cutting and pruning wood, branches, ice and other themes. Mainly used for landscaping pruning, replacing the special guide board can be used as a large wood carving, ice carving large outline modification
Chainsaw products have many advantages, such as large power, small vibration, high cutting efficiency and low cutting cost. It has become the leading hand-held logging machine in the forest area.
The chainsaw shock absorption system uses springs and high strength rubber shock absorption. Sprocket form for positive teeth, make the assembly chain more simple and convenient!
Excellent and reliable ignition device, oil supply system using adjustable oil pump.
Before use, you must read the operation manual carefully to understand the characteristics, technical performance and precautions of the chainsaw.
Before use, the fuel tank, the fuel tank of the machine to add enough oil; Adjust the tightness of the saw chain, neither too loose nor too tight.
Before operation, the operator should wear work clothes, helmet, protective gloves, dust-proof glasses or facial protective cover.
After the engine starts, the operator holds the rear saw handle with his right hand and the front saw handle with his left hand. The Angle between the machine and the ground should not exceed 60 degrees, but the Angle should not be too small, otherwise it is not easy to operate.
When cutting, cut off the lower branches first, and then saw the upper branches. Heavy or large branches should be cut in sections.
25cc petrol chainsaw,chainsaw parts,cordless chain saw,pole chain saw,gasoline chain saw
Shaoxing Haotuo Machinery CO., LTD. , https://hotochainsaw.com