Rat 5-hydroxyindoleacetic acid (5-HIAA) ELISA kit instruction manual

This kit is for research use only.

Drug Name:

Generic name: Rat 5-hydroxyindoleacetic acid (5-HIAA) ELISA kit

purpose of usage:

This kit is used to determine the content of 5-hydroxyindoleacetic acid (5-HIAA) in rat serum, plasma and related liquid samples.

Experimental principle

This kit uses the double antibody sandwich method to determine the level of 5-hydroxyindoleacetic acid (5-HIAA) in the specimen. Microporous plates were coated with purified rat 5-hydroxyindoleacetic acid (5-HIAA) antibody to prepare solid-phase antibodies, and 5-hydroxyindoleacetic acid (5-HIAA) was sequentially added to the microwells coated with monoclonal antibody , Combined with HRP-labeled 5-hydroxyindoleacetic acid (5-HIAA) antibody to form an antibody-antigen-enzyme-labeled antibody complex, after thorough washing, the substrate TMB is added for color development. TMB is converted into blue under the catalysis of HRP enzyme, and into the final yellow under the action of acid. The color depth is positively correlated with 5-hydroxyindoleacetic acid (5-HIAA) in the sample. The absorbance (OD value) was measured with a microplate reader at a wavelength of 450 nm, and the concentration of human 5-hydroxyindoleacetic acid (5-HIAA) in the sample was calculated by a standard curve.

Kit composition

20 times concentrated washing liquid

30ml Ã— 1 bottle

Stop solution

6ml Ã— 1 bottle

Enzyme reagent

6ml Ã— 1 bottle

Standard product (18ng / L)

0.5ml Ã— 1 bottle

Enzyme coated plate

12 holes Ã— 8

Standard dilution

1.5ml Ã— 1 bottle

Sample diluent

6ml Ã— 1 bottle

Instructions

1 serving

Developer A liquid

6ml Ã— 1 bottle

Sealing film

2 sheets

Developer B liquid

6ml Ã— 1 / bottle

sealed bag

Specimen requirements

1. Specimens are extracted as soon as possible after collection, and extraction is performed according to relevant literature, and experiments should be conducted as soon as possible after extraction. If the test cannot be performed immediately, the specimen can be stored at -20 â„ƒ, but repeated freezing and thawing should be avoided

2. The samples containing NaN3 cannot be detected because NaN3 inhibits horseradish peroxidase (HRP) activity.

Steps

1. Dilution and loading of standard products: set 10 standard wells on the enzyme-coated plate, add 100 Î¼l of standard products in the first and second wells, and then add standard products in the first and second wells 50Î¼l of diluent, mix well; then take 100Î¼l from the first well and the second well and add them to the third and fourth wells respectively, and then add 50Î¼l of standard diluent to the third and fourth wells respectively, mix well; Then take 50Î¼l each in the third and fourth wells and discard it, then add 50Î¼l each to the fifth and sixth wells, and then add 50ul of the standard dilution solution to the fifth and sixth wells respectively, and mix well; After mixing, take 50Î¼l from the fifth and sixth wells and add them to the seventh and eighth wells respectively. Then add 50Î¼l of the standard dilution solution to the seventh and eighth wells respectively. Take 50Î¼l from the eight wells and add them to the ninth and tenth wells. Then add 50Î¼l of the standard dilution solution to the ninth and tenth wells. After mixing, take 50Î¼l from the ninth and tenth wells and discard. (After dilution, the volume of each well is 50Î¼l, and the concentrations are 12ng / L, 8ng / L, 4ng / L, 2ng / L, 1ng / L).

2. Add samples: set up blank wells (the blank control wells do not add samples and enzyme reagents, the rest of the steps are the same) and the sample wells to be tested. Add 40Î¼l of sample diluent to the test sample well of the enzyme-coated plate, and then add 10Î¼l of the sample to be tested (the final dilution of the sample is 5 times). Add the sample and add the sample to the bottom of the well of the microplate, try not to touch the wall of the well, shake gently to mix.

3. Incubation: Seal the plate with a sealing plate and incubate at 37 Â° C for 30 minutes.

4. Mixing solution: dilute 20 times concentrated washing liquid with distilled water 20 times and reserve

5. Washing: Carefully peel off the sealing film, discard the liquid, spin dry, fill each well with the washing liquid, let it stand for 30 seconds and then discard, repeat 5 times and pat dry.

6. Add enzyme: add 50Î¼l of enzyme label reagent to each well, except blank well.

7. Incubation: The operation is the same as 3.

8. Washing: The operation is the same as 5.

9. Color development: add 50Î¼l of developer A to each well, then add 50Î¼l of developer B, mix gently, and develop at 37 Â° C in the dark for 15 minutes.

10. Termination: Add 50Î¼l of stop solution to each well to stop the reaction (at this time the blue will turn to yellow).

11. Determination: Measure the absorbance (OD value) of each well in sequence with the blank air conditioner at zero and 450 nm wavelength. The measurement should be carried out within 15 minutes after adding the stop solution.

Calculation

Taking the concentration of the standard as the abscissa and the OD value as the ordinate, draw a standard curve on the coordinate paper, and find the corresponding concentration from the standard curve according to the OD value of the sample; then multiply by the dilution factor; Calculate the linear regression equation of the standard curve with the OD value, substitute the OD value of the sample into the equation, calculate the sample concentration, and multiply it by the dilution factor to obtain the actual concentration of the sample.

Precautions

1. The kit should be equilibrated at room temperature for 15-30 minutes before being taken out of the refrigerated environment. If the enzyme label coated plate is unopened, the strip should be stored in a sealed bag.

2. Crystals may be precipitated in the concentrated washing liquid, which can be heated and dissolved in a water bath during dilution, and the results will not be affected during washing.

3. The sampler should be used at each step of sample addition, and the accuracy should be regularly checked to avoid test errors. It is best to control the sampling time within 5 minutes. If there are many specimens, it is recommended to use a volley gun to add samples.

4. Please make a standard curve at the same time of each measurement, it is best to make a double hole. If the content of the test substance in the specimen is too high (the OD value of the sample is greater than the OD value of the first well of the standard well), please first dilute it with a certain multiple (n times) of the sample diluent and then determine it. When calculating, please multiply the total dilution Multiple (Ã— n Ã— 5).

5. The sealing film is limited to one-time use to avoid cross-contamination.

6. Please keep the substrate away from light.

7. Strictly follow the instructions, and the test results must be determined by the microplate reader.

8. All samples, washing liquids and various wastes should be treated as infectious agents.

9. The components of different batches of this reagent shall not be mixed.

10. If there is any difference with the English manual, the English manual shall prevail.

examination range:

0.5ng / L -15ng / L

specification:

96 servings / box

Storage conditions and validity period

1. Kit storage :; 2-8 â„ƒ.

2. Validity: 6 months

Xiamen Huijia Biotechnology Co., Ltd. is a professional agent for many well-known brands in the international life science field. Committed to the sales and promotion of various ELISA kits, immunohistochemical kits, primary and secondary antibodies, cytokines, biological reagents, pipettes, and consumables.

Spirits

Spirits seem to precede the earliest stages of Chinese civilization. They include rice and grape wine, beer, and various liquors including Chinese liquor, the most-consumed distilled spirit in the world. Nonetheless, there are many cultural parallels with the use of wine in European culture. Chinese food employs liquor in its recipes and formal dining in an analogous manner; likewise, there are many parallels in upper-class etiquette and religious observance. It appears prominently in all of the Chinese classics, including the Rites of Zhou and the Record of Rites, and has been a constant theme of Chinese poetry since its origins, all similar to the treatment of wine in Europe.

Description:
Usage: Liquor/Wine/Beverage

Material: Extra-flint, high-flint and flint glass

Technology: Machine made

Volume: 50 to 3000ml or as your requirements

Weight: 150 to 2000g and so on

Sealing type: Screw cap or cork

Painting: Any color as you requirement

Quality control: SGS, FDA, ISO9001, ISO14001

Deep processing: Silk screen, decal, spray painting, electroplating, frosting, sand blasting.

Delivery term: EXW, FOB, CIF

Payment terms: T/T

Lead time: New design drawing confirm within 3days, Sample mold within 20 days, bulk molds within 30 days, produce in bulk within 30 days

FAQ:

Q: Are you a manufacture or a trading company?

A: We are a manufacture which located in Chengdu city and Yibin city, Sichuan, China.

Q: Can you customize the products?

A: Yes, we are professional to customize glass bottle, we can design the new drawings and open the new molds according to your requirement.

Q: Do you provide free sample?

A: Yes, for cooperation sincerity, we are glad to provide you samples for free, but for new customer, the express cost need to be paid.

Q: What is your MOQ?

A: Our only standard for MOQ is a 40 feet container.

Q: How long is your sample lead time, mold need time and production lead time?

A: New design drawing confirm within 3 days, sample mold within 20 days, bulk molds within 30 days, produce in bulk within 30 days

Spirits Bottle

Spirits Bottle,Glass Spirits Bottle,Color Printing Spirits Bottle,Porcelain Liquor Bottle

SICHUAN YIBIN GLOBAL GROUP CO.,LTD. , https://www.globalglassbottle.com