The wardrobe is the storage furniture that can not be lacked in every family. There are many types of wardrobes that can be selected in the market. Of course, there are also choices for woodworking to make wardrobes. It is more economical and practical, but many people will have a wardrobe. Tangled, is the wardrobe good or not top?
The advantages of wardrobe to the top
1. Don't worry about the difficulty of cleaning up the top.
2, increased storage space, make full use of the space in the air to replace the season's clothes quilt.
3. Improve the overall texture of the decoration.
Shortcomings from the closet to the top
1. The height of the wardrobe to the top is too high, the pressure on the side panels is relatively large, the time is prone to deformation for a long time, the life of the wardrobe is shortened, and it can be properly thickened to remedy.
2, poor lighting or relatively small rooms, may create a sense of oppression.
3, because the wood plates are all containing water, affected by the temperature will cause thermal expansion and contraction, the wardrobe will do the top will damage the top wall of the decoration.
Generally, the height of the rough house in the home is 2.75, and the normal floor is five centimeters. The ceiling or central air conditioner is 2.4. So do a good job, because there is a little bit of dust left on the top, and 2.4 meters will not feel depressed. The furniture factory uses the multi-layer board to be harder. The board is normally 2.4 and will not be deformed.
Or to the top of the wardrobe can also be divided into the general close to the top of the wardrobe is basically the base cabinet to achieve 2.2 meters, and then do the top cabinet. And our furniture designers cleverly designed the uniform appearance, moving the dividing points of the upper and lower cabinets down to 1.6-1.8 meters, and the big ones are much easier to put them up :)
design diagram:
Do the top wardrobe must pay attention to certain details, if it is fixed, if the bedroom does not make a ceiling, do the plaster corner line. Xiao Bian suggested to make the wardrobe first, then stick the plaster corner line.
This method does not damage the wardrobe, and the plaster corner line can be integrated into the wardrobe, as shown below.
In the case of custom-made wardrobes, the top of the closet must be reserved for a sealing distance of 10 cm, and the plaster line is no more than 10 cm, usually 5 cm or 7.5 cm.
But here are a few negative textbooks to give you a reference to avoid the same problem.
Gap problems <br> Customized wardrobes are generally square, but if the quality of the house is flawed, it will generally not be flush with the ground, and there will be such a clear gap.
If the gap is not too large, you can use the putty to repair the flat. However, considering that the cold shrinkage between the wood board and the putty may cause cracks, it is better to consider using the porcelain white glass glue to hit the gap.
Coordination with the ceiling <br> If it is a large and obvious gap, there is no way to remedy it with glass glue and putty, you have to use plaster line, PU line or woodwork ceiling to cover.
However, in addition to the whole house customization, a single wardrobe customization may present the following tragedy. Because the decorative lines on the top of the cabinet and the sideline style of the room are different, the final finished product is very ugly. In order to avoid this situation, before the custom wardrobe, we must consider the transition position, choose the same style of decorative edge or do the same style of woodworking ceiling.
The best solution is to do the wardrobe first, and then do the ceiling of this part, whether it is PU, plaster line, woodworking, as long as the two sides of the wardrobe and the ceiling are communicated in advance, the construction is well coordinated, this situation can be completely avoided.
Plate size problem <br> The standard woodworking board is 1220mmX2440mm, which means that if the wardrobe is to be more than 2.4 meters high, it is necessary to build a board, so if it exceeds 2.4m, it is better to plan one more compartment. The wardrobe does not have a side against the wall. It is best to use two 18mm plates to fight together (if you want to be safe, you can add a 12mm plate to the inside), so that you can improve the support of the wardrobe.
Before you make a wardrobe, you should consider the partition. If you exceed 2.4m, you will have a top cabinet. It is better to fully consider the effect of the cooperation with the ceiling.
High-quality wardrobes need to use high-quality plates to produce and sell healthy and environmentally-friendly plates for the people of the country. This is the goal of the good wife. "Health and environmental protection" is the most basic point of view that the good wife spares no effort to pursue.
Good wife's plates, floors, and wardrobes are mainly environmentally friendly substrates. Nano-silico-titanium self-cleaning agents with unique molecular sieve structure are added to the surface layer, which can effectively adsorb and decompose free formaldehyde in the air. The effect of removing indoor formaldehyde and purifying the air is achieved, and the aldehyde is completely removed, and care is taken care of.
Company Address: 10th Floor, Building A, Taihe Center, No. 2013, Sunwu Road, Suzhou (Taihu National Tourism Resort)
Official website:
National franchise hotline
The advantages of wardrobe to the top
1. Don't worry about the difficulty of cleaning up the top.
2, increased storage space, make full use of the space in the air to replace the season's clothes quilt.
3. Improve the overall texture of the decoration.
Shortcomings from the closet to the top
1. The height of the wardrobe to the top is too high, the pressure on the side panels is relatively large, the time is prone to deformation for a long time, the life of the wardrobe is shortened, and it can be properly thickened to remedy.
2, poor lighting or relatively small rooms, may create a sense of oppression.
3, because the wood plates are all containing water, affected by the temperature will cause thermal expansion and contraction, the wardrobe will do the top will damage the top wall of the decoration.
Generally, the height of the rough house in the home is 2.75, and the normal floor is five centimeters. The ceiling or central air conditioner is 2.4. So do a good job, because there is a little bit of dust left on the top, and 2.4 meters will not feel depressed. The furniture factory uses the multi-layer board to be harder. The board is normally 2.4 and will not be deformed.
Or to the top of the wardrobe can also be divided into the general close to the top of the wardrobe is basically the base cabinet to achieve 2.2 meters, and then do the top cabinet. And our furniture designers cleverly designed the uniform appearance, moving the dividing points of the upper and lower cabinets down to 1.6-1.8 meters, and the big ones are much easier to put them up :)
design diagram:
Do the top wardrobe must pay attention to certain details, if it is fixed, if the bedroom does not make a ceiling, do the plaster corner line. Xiao Bian suggested to make the wardrobe first, then stick the plaster corner line.
This method does not damage the wardrobe, and the plaster corner line can be integrated into the wardrobe, as shown below.
In the case of custom-made wardrobes, the top of the closet must be reserved for a sealing distance of 10 cm, and the plaster line is no more than 10 cm, usually 5 cm or 7.5 cm.
But here are a few negative textbooks to give you a reference to avoid the same problem.
Gap problems <br> Customized wardrobes are generally square, but if the quality of the house is flawed, it will generally not be flush with the ground, and there will be such a clear gap.
If the gap is not too large, you can use the putty to repair the flat. However, considering that the cold shrinkage between the wood board and the putty may cause cracks, it is better to consider using the porcelain white glass glue to hit the gap.
Coordination with the ceiling <br> If it is a large and obvious gap, there is no way to remedy it with glass glue and putty, you have to use plaster line, PU line or woodwork ceiling to cover.
However, in addition to the whole house customization, a single wardrobe customization may present the following tragedy. Because the decorative lines on the top of the cabinet and the sideline style of the room are different, the final finished product is very ugly. In order to avoid this situation, before the custom wardrobe, we must consider the transition position, choose the same style of decorative edge or do the same style of woodworking ceiling.
The best solution is to do the wardrobe first, and then do the ceiling of this part, whether it is PU, plaster line, woodworking, as long as the two sides of the wardrobe and the ceiling are communicated in advance, the construction is well coordinated, this situation can be completely avoided.
Plate size problem <br> The standard woodworking board is 1220mmX2440mm, which means that if the wardrobe is to be more than 2.4 meters high, it is necessary to build a board, so if it exceeds 2.4m, it is better to plan one more compartment. The wardrobe does not have a side against the wall. It is best to use two 18mm plates to fight together (if you want to be safe, you can add a 12mm plate to the inside), so that you can improve the support of the wardrobe.
Before you make a wardrobe, you should consider the partition. If you exceed 2.4m, you will have a top cabinet. It is better to fully consider the effect of the cooperation with the ceiling.
High-quality wardrobes need to use high-quality plates to produce and sell healthy and environmentally-friendly plates for the people of the country. This is the goal of the good wife. "Health and environmental protection" is the most basic point of view that the good wife spares no effort to pursue.
Good wife's plates, floors, and wardrobes are mainly environmentally friendly substrates. Nano-silico-titanium self-cleaning agents with unique molecular sieve structure are added to the surface layer, which can effectively adsorb and decompose free formaldehyde in the air. The effect of removing indoor formaldehyde and purifying the air is achieved, and the aldehyde is completely removed, and care is taken care of.
Company Address: 10th Floor, Building A, Taihe Center, No. 2013, Sunwu Road, Suzhou (Taihu National Tourism Resort)
Official website:
National franchise hotline
Adjustable Horizontal Vertical Wheel Stand Rack
2000w 2500W Led Near Infrared red light therapy Lamp With Adjustable Horizontal Vertical Wheel Stand Rack,full body therapy light machine
Adjustable Horizontal Vertical Wheel Stand Rack,Red Infrared Light Therapy,Red Light Therapy Lamp,,Red Light Therapy Stand
Shenzhen Bonliter Optoelectronic Co., Ltd. , https://www.szbonliter.com